Abb. 1: Schematische Darstellung der Bindungsmechanismen von Füllstoff zur Polymermatrix.

Acrylonitrile butadiene Rubber (NBR) in sealing Applications

Influence of fillers on the mechanical and tribological properties of acrylo-nitrile-butadiene-vulcanisates (NBR)

Acrylonitrile butadiene rubber (NBR) in sealing applications are highly reinforced with various fillers to improve their end-use properties. more...

December 5. 2018 - Research news


Influence of CNT

Impact of Softener and Filler on the Rheological and Dielectric Response of Elastomer Melts

The impact of softeners (DEHP, DBP) on the rheological response of HNBR melts is discussed in the frame of compatibility and wall slip effects based on entropic segregation. The influence of filler flocculation (carbon black, CNT) on oscillatory and steady shear flow properties is described and analyzed by dielectric spectroscopy measured online in a plate-plate […] more...

October 10. 2016 - Research news

Combined Dielectric DEA and Dynamic Mechanical Thermal Analysis DMTA in Compressions Mode

Simultaneous Measure

Combined Dielectric (DEA) and Dynamic Mechanical Thermal Analysis (DMTA) in Compression Mode

The design of a new experimental setup that combines dielectric spectroscopy (DEA) with dynamic mechanical thermal analysis (DMTA) to perform simultaneous dielectric and dynamic mechanical measurements is presented here for the first time. more...

March 22. 2016 - Research news

Chakrit Sirisinha_Unbenannt

(HNBR): Effects of Co-Agent, Processing Aids and Softener

Processability and Mouldability of hydrogenated Acrylonitrile Butadiene Rubber

Rheological properties of carbon black filled hydrogenated acrylonitrile butadiene rubber (HNBR) incorporated with various loadings of co-agents (Sartomer TRIM, Sartomer ZDA), processing aids (Struktol WB222 and Struktol NS60) and softener (TOTM) were determined and compared. With these chemicals, improvements in processability and mouldability of HNBR compounds are observed at different magnitudes. Struktol WB222 provides the […] more...

January 28. 2016 - Research news


Accelerators for SBR

Influences of binary Accelerators on the physico-mechanical and dielectric Behaviors of Styrene Butadiene Rubber

The physico-mechanical properties, curing characteristics, swelling behavior and dielectric properties of carbon black filled styrene butadiene rubber with different binary accelerator systems are investigated. more...

October 9. 2015 - Research news


Free-Volume Changes in EVA Composites Studied by Positron Annihilation Lifetime Technique

The influence of different concentrations (0 - 60 wt %) of carbon black (HAF) filler on macrostructure and microstructure of ethylene vinyl acetate (EVA) composites was studied through electrical, mechanical measurements and positron annihilation lifetime (PAL) spectroscopy. The electrical conductivity measurements showed an abrupt increase when the concentration of HAF reaches 30 wt%. more...

April 16. 2015 - Research news